UDS4REGHE - LED universal dimming station 4-gang
Rail mounting device, 8 rail units - Quad Industry GmbH
Àðòèêóë: UDS4REGHE
Íàèìåíîâàíèå: LED universal dimming station 4-gang
Rail mounting device, 8 rail units
Ïðîèçâîäèòåëü: JUNG
|
|

LED universal dimming station 4-gang
Rail mounting device, 8 rail units
Intended use
* Switching and dimming of incandescent lamps, HV halogen lamps, dimmable HV-LED lamps, dimmable compact fluorescent lamps, dimmable inductive transformers with LV halogen or LV LED lamps, dimmable electronic transformers with LV halogen or LV LED lamps
* Mixed loads of the specified types (do not mix C and L loads)
* Operation by means of push-button sensors, sensor modules, push-button modules or unlit installation buttons
* Mounting on DIN rail in distribution boxes
* It is not possible to operate the device with universal amplifiers in conjunction with electronic transformers! Please use TRONIC amplifiers for power extension when operating electronic transformers.
Product characteristics
* Local control. The dimming station can be controlled using the keypad when the control units are not connected.
* Activation of status LEDs on the control units. The relay station has the activation outputs A1’...A4’ for this purpose.
* Electronic short circuit protection with permanent cut-off after 7 seconds
* Electronic overtemperature protection
* Integrated memory function for each channel (storing of brightness value)
* Lamp-saving soft start
* Switching off with dim-down function
* Increasing the capacity by means of parallel wiring of outputs possible
* Connection of amplifier possible
* Special connection for hotel card switch
* Central switching function All On, All Off
* Parallel connection of two dimming stations (or dimming + relay station) possible
Function hotel card switch
In combination with a hotel card switch (ref.-no.: ..590 CARD..): When plugging in the hotel card the light will be switched on with the stored brightness level. After removing the hotel card the light remains on and can be controlled for 1 more minute. After the elapsed time the light dims down (within an adjustable time of 30 seconds to 3 minutes) to minimum brightness and then switches off. The dimming station can be controlled again after plugging in the hotel card.
Technical data
Rated voltage: AC 230/240 V ~, 50/60 Hz
Power loss: max. 20 W
Stand-by power: max. 2 W
Terminals -, +
Control voltage: DC 24 V SELV
Current carrying capacity: ? 80 mA
Length of control cable: max. 100 m
Number of control units
Sensor module (ref.-no. SM 1608): max. 4 (also when relay/dimming stations are connected in parallel)
Push-button module (ref.-no. 4008 TSM): max. 4 (also when relay/dimming stations are connected in parallel)
Push-button module 24 V AC/DC (make contact): depending on push-button module, consider current consumption
Switching inputs E1ON/OFF ... E4ON/OFF
Control voltage: DC 24 V SELV
Resistance Ri: 200 k?
Activation outputs A1‘ ... A4‘
Control voltage: DC 24 V SELV
Current carrying capacity: 10 mA
Resistance Ra: 330 ?
Connection
Mains / load outputs / key card switchscrew terminals
single wire: 1.5 ... 4 mm2
stranded without ferrule: 0.75 ... 4 mm2
stranded with ferrule: 0.5 ... 2.5 mm2
Switching inputs / activation outputs / control units: screw terminals
single wire: 1.5 mm2
stranded without ferrule: 1 mm2
stranded with ferrule: 0.75 mm2
Load outputs A1 ... A4
Contact type: ?
Length of output cable, per channel: max. 100 m
Connected load per channel
Incandescent lamps: 20 ... 150 W
HV halogen lamps: 20 ... 150 W
Electronic transformers: 20 ... 150 W
Inductive transformers: 20 ... 150 VA
Dimmable HV LED lamps: typical 3 ... 30 W
Dimmable compact fluorescent lamps: typical 3 ... 30 W
Ohmic-capacitive: 20 ... 150 W
Ohmic-inductive: 20 ... 150 VA
Capacitive-inductive: not permitted
Reduction of load for every 5 °C exceededing 45 °C: ?15 %
Max. load for outputs connected in parallel is limited to 80 %.
Mounting width: 144 mm (8 rail units)
Manufacturer: JUNG
Ref.-no.: UDS 4 REGHE
|
Íàçàä â ðàçäåë
|