ГлавнаяКаталогjung12512521252UD
 

1252UDE - Universal 2-gang dimmer insert - Quad Industry GmbH

Артикул: 1252UDE
Наименование: Universal 2-gang dimmer insert
Производитель: JUNG




Universal 2-gang dimmer insert

Intended use
*     Switching and dimming of incandescent lamps, HV halogen lamps and dimmable inductive transformers or TRONIC transformers with halogen lamps
*     Suitable for mixed load up to the specified output
*     Suitable for luminaire groups via the two independent outputs a1 and a2
*     Installation in appliance box according to DIN 49073
*     Operation with suitable cover


Product characteristics
*     Electronic short-circuit protection with permanent switch-off after 7 seconds at the latest
*     Electronic overtemperature protection
*     Lamp-saving soft start
*     Power extension through amplifiers
*     Different load types are possible on the two outputs
*     Asymmetric load distribution possible
*     Automatic setting of the dimming principle suitable for the load
*     Connection of more than one 2-wire extension is possible
*     Suitable amplifiers: ULZ 1215 REG, 247 EB or 246 EB (max. 10)
*     When using 247 EB or 246 EB, charge dimmer with minimum capacity!

Connection of satellite units (combinations possible):
Satellite insert "2-wire", ref.-no.: 1220 NE
Centre plate (ref.-no.: ..1561.07..) has same functionality as that on universal 2-gang dimmer insert
Number of satellite units: unlimited
Total length of satellite cables: max. 100 m
The satellite unit always controls both outputs at the same time.Note: Satellite operation is only possible, when a centre plate is placed on the main unit. Satellite operation via mechanical push-buttons is not possible.
Technical data
Rated voltage: AC 230 V ~, 50/60 Hz
Connected load per output: 50 ... 260 W/VA
Type of loads: 230 V incandescent lamps (resistive load, trailing edge phase control)
230 V halogen lamps (resistive load, trailing edge phase control)
TRONIC transformers (capacitive load, trailing edge phase control)
inductive transformers (inductive load, leading edge phase control)
Mix of the specified load types (do not mix capacitive loads with inductive loads).
When using mixed loads with inductive transformers, the ohmic load must not exceed 50 %.
Connection: screw terminals
Terminals for: 2 x 2.5 mm2 or 1 x 4 mm2
Approvals: VDE

Manufacturer: JUNG
Ref.-no.: 1252 UDE

Назад в раздел