| | SIMATIC DP, ELECTRONIC SUBMODULE, FOR ET200ISP, 2DO RELAY UC60V / 2A |
| |
| Input current |
| from load voltage L+ (without load), max. | 120 mA |
| Power losses |
| Power loss, typ. | 1 W |
| Digital outputs |
| Number/binary outputs | 2 |
| Functionality/short-circuit strength | Yes |
| Output current |
| for signal "1" rated value | 2 A |
| Output delay with resistive load |
| 0 to "1", max. | 8 ms |
| 1 to "0", max. | 3 ms |
| Parallel switching of 2 outputs |
| for increased power | No |
| for redundant control of a load | No |
| Switching frequency |
| with resistive load, max. | 0.5 Hz; See data in manual |
| with inductive load, max. | 0.2 Hz; See data in manual |
| Relay outputs |
| Switching capacity of contacts |
| at ohmic load, up to 60 °C, max. | 2 A; See data in manual |
| Thermal continuous current, max. | 2 A; See data in manual |
| Cable length |
| Cable length, shielded, max. | 500 m |
| Cable length unshielded, max. | 500 m |
| Interrupts/diagnostics/status information |
| Substitute values connectable | Yes |
| Alarms |
| Alarms | No |
| Diagnostic alarm | Yes |
| Hardware interrupt | No |
| Diagnostic messages |
| Diagnostic information readable | Yes |
| Wire break | No; Cannot be determined in contact power circuit |
| Short circuit | No; Cannot be determined in contact power circuit |
| Diagnostics indication LED |
| Group error SF (red) | Yes |
| Status indicator digital output (green) | Yes; Per channel |
| Ex(i) characteristics |
| Max. values of output circuits (per channel) |
| Uo (output no-load voltage), max. | 60 V |
| Um (fault voltage), max. | 250 V |
| Ta (permissible ambient temperature), max. | 70 °C |
| Galvanic isolation |
| Galvanic isolation digital outputs |
| between the channels | Yes |
| between the channels and the backplane bus | Yes |
| between the channels and the load voltage L+ | Yes; Channels and power bus |
| Standards, approvals, certificates |
| CE mark | Yes |
| Use in hazardous areas |
| Type of protection acc. to EN 50020 (CENELEC) | II 2 G and I M2 Ex eibmb IIC T4; Ex eibmb I |
| Type of protection acc. to KEMA | 07 ATEX 0180 |
| Dimensions |
| Width | 30 mm |
| Height | 129 mm |
| Depth | 136.5 mm |
| Weight |
| Weight, approx. | 280 g |
| Status | Mar 12, 2012 |
