| | AS-I DATA DECOUPL 1 X 4A SPRING AS-INTERFACE SINGLE DATA DECOUPLING UNIT, IP20, SLIMLINE S22.5 SPRING-LOADED TERMINALS, MODULE WIDTH 22.5 MM, IN: 24 V / 30 V DC OUT: 1 X AS-I, 4 A INTEGR. OVERLOAD PROTECTION, INTEGR. EARTH FAULT DETECTION, SIGNALING CONTACT, REMOTE RESET |
| |
| General technical data: |
| product brand name | | AS-Interface |
| product designation | | Single data decoupling module |
| Design of the product | | SlimLine S22.5 - Module to beused in the IP20 control cabinet |
| Protection class IP | | IP20 |
| Installation altitude / at a height over sea level / maximum | m | 2,000 |
| Ambient temperature | | |
| | °C | -25… +70 |
| | °C | -40… +85 |
| Relative humidity / at 25 °C / during operating / maximum | % | 70 |
| Item designation / according to DIN 40719 extendable after IEC 204-2 / according to IEC 750 | | A |
| Item designation / according to DIN EN 61346-2 | | A |
| Active power supplied | W | 120 |
| Mechanical operating cycles as operating time / of the signal contacts / typical | | 1,000,000 |
| Product function | | |
| | | No |
| | | Yes |
| | | Yes |
- short-circuit to earth recognition
| | Yes |
- test function of signaling contacts
| | Yes |
- adapted for grounded AS-i networks
| | Yes |
- adapted for non-grounded AS-i networks
| | Yes |
- adapted for AS-i Power24V
| | Yes |
- sequential connected time-delay
| | No |
- AS-interface data decoupling
| | Yes |
| Reset function | | yes |
| Adjustable response current | | |
- of the current-dependent overload release
| A | 2.5… 4 |
| Number of electrical connections / for alarm contact | | 2 |
| Number of outputs / for AS Interface / maximum | | 1 |
| Type of display / as status display by LED | | yes |
| Number of switching contacts / as make contact / for reporting function | | 1 |
| Design of the switching contact / as make contact / for reporting function | | yes |
| |
| Communication: | | |
| Protocol / will be supported / AS interface protocol | | Yes |
| |
| Auxiliary circuit: | | |
| Operating current / of the auxiliary contacts | | |
| | A | 3 |
| | A | 1 |
| |
| Ein- und Ausgänge: | | |
| Type of voltage | | |
| | | DC |
| | | DC |
| Characteristic feature of the output / short-circuit protected | | Yes |
| Output voltage | | |
| | V | 30 |
| | | |
| | V | 20.5… 31.6 |
| | V | 24 |
| Output current / for DC / maximum | A | 4 |
| Input voltage | | |
| | V | 30 |
| | | |
| | V | 21… 32 |
| | V | 24 |
| Input current / for DC / maximum | A | 4.1 |
| |
| Short-circuit: | | |
| Design of the short-circuit protection | | electronic |
| |
| Einbau/Befestigung/Abmessungen: | | |
| Built in orientation | | vertical |
| Type of mounting | | 35-mm DIN rail mounting or wall mounting with plug-in flaps |
| Width | mm | 22.5 |
| Height | mm | 104.9 |
| Depth | mm | 121.2 |
| Design of the electrical connection / for auxiliary and control current circuit | | spring-loaded terminals |
| Product function / removable terminal for auxiliary and control circuit | | Yes |
| Type of the connectable conductor cross-section | | |
| | | |
| | | 2x (0.25 ... 1.5 mm²) |
| | | |
- with conductor end processing
| | 2x (0.25 ... 1.5 mm²) |
- without conductor final cutting
| | 2x (0.25 ... 1.5 mm²) |
- for AWG conductors / for auxiliary contacts
| | 2x (24 ... 16) |
| Verification of suitability | | CE / UL / CSA |
| Acceptability for application / safety-related circuits | | Yes |
| |
| Certificates/approvals: | | |
| General Product Approval | other | | | |
| | |
| |
| last change: | Mar 14, 2012 |
