WL2200WW - Observers
System control unit
for max. 8 sensors
to be installed in combination with system sensor ref.-no.: WS 180 WW - Quad Industry GmbH
Артикул: WL2200WW
Наименование: Observers
System control unit
for max. 8 sensors
to be installed in combination with system sensor ref.-no.: WS 180 WW
Производитель: JUNG
|
|
![](http://www.quad-industry.com/titan_img/JUNG/img/JUNG_WL2200WW.png)
Observers
System control unit
for max. 8 sensors
to be installed in combination with system sensor ref.-no.: WS 180 WW
Intended use
* Automatic switching of electrical loads for the duration of a settable time when the brightness drops below a brightness threshold
* System sensors report detected thermal movements to the performance unit
* Surface-mounting in indoor and outdoor areas
Product characteristics
* Device reacts to motion signals of system sensors
* Power supply for system sensors
* Brightness threshold settable
* Switch-on time settable
* Forced switch-off settable
Important: Energy saving lamps cause high inrush currents which may cause the switch contact to get stuck. Then a reduction of capacity is required! Please check suitability of lamps before installation.
Technical data
Rated voltage: AC 230 V ~, 50 Hz
Switch contact: relay, mains potential
Switching capacity
Incandescent lamps: 2300 W
HV halogen lamps: 2300 W
Fluorescent lamps
– non-compensated: 1200 W
– parallel compensated: 920 W
– lead-lag circuit: 2300 W
Power consumption: 1.1 W
Temperature range: ?25 ... +55 °C
Switch-on current: max. 20 A
Shut-off delay: approx. 4 s ... 15 min, retriggered
Accuracy: ± 10 %
Brightness setting: approx. 3 ... 80 lx
Accuracy: ± 35 %
Limit: forced switching-off after max. 90 min
Protection level: IP 55
Radio interference suppression: acc. to VDE 0876 part 1/12.88
Approvals: VDE
Colour: white
Manufacturer: JUNG
Ref.-no.: WL 2200 WW
|
Назад в раздел
|