WL2200-2REG - Observers
System control unit for rail mounting
for max. 16 sensors, 8 sensors per channnel
to be installed in combination with system sensor ref.-no.: WS 180 WW
Rail mounting device, 4 rail units - Quad Industry GmbH
Артикул: WL2200-2REG
Наименование: Observers
System control unit for rail mounting
for max. 16 sensors, 8 sensors per channnel
to be installed in combination with system sensor ref.-no.: WS 180 WW
Rail mounting device, 4 rail units
Производитель: JUNG
|
|
Observers
System control unit for rail mounting
for max. 16 sensors, 8 sensors per channnel
to be installed in combination with system sensor ref.-no.: WS 180 WW
Rail mounting device, 4 rail units
Intended use
* Switching of electrical loads for the duration of an adjustable time depending on the ambient brightness
* Operation with suitable system sensors
* Installation in distribution boxes on DIN rail according to DIN EN 60715
Product characteristics
* Device reacts to motion detection of system sensors
* Brightness threshold can be adjusted separately for both channels
* Switch ON time can be adjusted separately for both channels
* Forced switch OFF can be adjusted separately for both channels, limit function
* Channel 1: non-floating make contact
* Channel 2: floating make contact
* Manual switch ON of both channels possible with push-button, break contact
Important: Energy saving lamps cause high inrush currents which may cause the switch contact to get stuck. Then a reduction of capacity is required! Please check suitability of lamps before installation.
Technical data
Rated voltage: AC 230 V ~, 50 Hz
Power consumption: approx. 1.8 W
Connected load at AC 230 V ~
Incandescent lamps: 2300 W
HV halogen lamps: 2300 W
Electronic transformers: 1200 W
Inductive transformers: 1200 VA
Fluorescent lamps
– non-compensated: 1200 W
– parallel compensated: 920 W
– lead-lag circuit: 2300 W
Rated current per channel: 10 A
Switch-on current per channel: max. 20 A
Min. switching current: 100 mA
Min. switching voltage: AC 12 V
Connection: screw terminals
single wire: 1.5 ... 4 mm2
stranded without ferrule: 0.75 ... 4 mm2
stranded with ferrule: 0.5 ... 2.5 mm2
Temperature range: ?25 ... +55 °C
Shut-off delay: approx. 4 s ... 15 min, retriggered
Accuracy: ± 10 %
Brightness setting: approx. 3 ... 80 lx
Accuracy: ± 35 %
Limit: forced switching-off after max. 90 min
Radio interference suppression: acc. to VDE 0876 part 1/12.88
Mounting width: 72 mm (4 rail units)
Approvals: VDE
Version: 2-channel
Manufacturer: JUNG
Ref.-no.: WL 2200-2 REG
|
Назад в раздел
|